:: SunStar ::
![]()
![]()
![]()
|
 |
  |
 |
| |
|
| 24 |
|
When "Err25(Drag-Limit Over!)" appears on OP Screen. |
 |
|
|
|
Cause : This error is caused when the stitch is out of range the maximum moving range.
Type : SPS/A - 1306, SPS/A - 1811, SPS/A - 2516, SPS/A - 5030 |
|
|
|
|
Solution : The maximum stitch width of one stitch is 12.9mm. Check whether the range is out of escape.
Solution : |
|
※ If the same errors constantly occur, refer to an A/S engineer for check.
|
|
