|
||||||||||||||||||||||||||||
| ||||||||||||||||||||||||||||



| HOME > Resource > VideoResource > Lockstitch > Electronicaly Controled > |
![]() |
![]() |
![]() |
|
| * Adobe Acrobat Reader is required for viewing the PDF documents. * Clicking the bottom part of the menu can download the Adobe Acrobat Reader file. |
|
![]() |
||||||||||
| Adjust the clearance of the shaking shaft bracket | Adjust the front & rear clearance of the needle bar | |||||||||
![]() ![]() |
||||||||||
| Tension adjustments of presser foot | Adjust the micro presser foot adjusting device | |||||||||
| Adjust the height of the presser foot | Adjust the height of the feed dog(p) | |||||||||
| Adjust the horizontal level of the feed dog(p) | Adjust the moving section of the feed dog(p) | |||||||||
| Set the feed cam | ||||||||||
![]() |
|||||||||||
| Set the moving section of the mes | Set the thread trimmer cam | ||||||||||
| Check the operating status of the mes bracket(Ass'y) | Replace the mes | ||||||||||
![]() |
||||||||||
| Adjust the tension of the upper thread | Adjust the thread take-up spring | |||||||||
| Adjust the lower thread tension | Adjust the height of the needle bar | |||||||||
| Adjust the hook time | Adjust the synchronizer position | |||||||||
| Adjust the upper thread supplying wire | Set the X-origin | |||||||||
| Set the Y-origin | ||||||||||
![]() |
||||||||||
| Adjust the belt tension | ||||||||||
![]() |
|||||||||||
| Check the lubrication | Check the hook's lubrication | ||||||||||
![]() |
||||||||||
| Head grounding | ||||||||||
![]() |
||||||||||
| Replace the gauges | ||||||||||
![]() |
||||||||||
| Needle plate, feed dog, presser foot, stopper | ||||||||||
![]() |